1、實驗室天花采用防塵，光滑，耐燃，鋼板夾心的彩鋼板，兩邊用槽型鋁封邊，彩鋼板與彩鋼板之間用中性瓷白玻璃膠密封；
1. The laboratory ceiling is made of dust-proof, smooth, fire-resistant, and steel plate sandwich color steel plates. Both sides are sealed with slot shaped aluminum, and the color steel plates are sealed with neutral porcelain white glass adhesive between them;
2、實驗室凈化區地面鋪貼專用PVC地板膠，防火等級為B1級，防酸、防堿、防腐蝕耐磨達到國家標準實驗室要求等級。
2. The floor of the laboratory purification area is paved with dedicated PVC floor adhesive, with a fire resistance rating of B1, and meets the national standard laboratory requirements for acid, alkali, corrosion, and wear resistance.
3、實驗室墻體為采用防塵，光滑，耐燃，鋼板夾心的彩鋼板墻體固定采用50×30槽型鋁做地槽，地槽固定采用鋼釘加木塊固定。
3. The laboratory wall is made of dust-proof, smooth, fire-resistant, and steel plate sandwich color steel plate fixed with 50 × 30 slot aluminum is used as the floor trough, and the trough is fixed with steel nails and wooden blocks.
4、地面與墻面，墻面與墻面，墻面與天花板交接均采用半徑50mm的鋁合金圓弧處理。
4. The connection between the ground and the wall, between the wall and the wall, and between the wall and ceiling is treated with an aluminum alloy arc with a radius of 50mm.
5、彩鋼板與彩鋼板之間用中性瓷白玻璃膠密封，防止有縫滋生細菌。
5. The neutral porcelain white glass adhesive is used to seal the gap between the color steel plate and the color steel plate to prevent bacterial growth.
6、柱面、陰陽角處理：鋼板夾芯彩鋼板隔斷之間陽角處裝鋁合金外圓弧，隔斷與隔斷之間，隔斷與天花之間，隔斷與地面之間的陰角封R50鋁合金內圓弧。圓角線三維匯交處安裝鋁合金頂球片，門口斷開處應收口，陽角柱與天花之交角。
6. Column surface and internal and external corner treatment: Install aluminum alloy outer arc at the external corner between steel plate sandwich color steel plate partitions, seal R50 aluminum alloy inner arc between partitions, between partitions and ceiling, and between partitions and ground. Install aluminum alloy top ball pieces at the three-dimensional intersection of the rounded corner line, and close the opening at the broken entrance. The intersection angle between the external corner column and the ceiling.
7、門窗：實驗室統一采用潔凈密封彩鋼鋼板門，門套為5cm寬1.2厚沙光鋁合金制作，門板上為5厘鋼化玻璃窗，下部分為彩鋼板填充。具體按照甲方要求，可開為900×2000mm、1500×2100等，實驗室統一采用潔凈密封彩鋼鋼板窗，1M以下為彩鋼板，1M以上為1.Om高的5mm的鋼化玻璃規格為：1500×1000、1000×1000 安全門為：1200*2100落地玻璃門。以上為標準配置。
7. Doors and windows: The laboratory adopts clean and sealed color steel plate doors, with a door pocket made of 5cm wide and 1.2 thick sanded aluminum alloy. The upper part of the door panel is a 5cm tempered glass window, and the lower part is filled with color steel plates. According to the specific requirements of Party A, it can be opened at 900 × 2000mm, 1500 × 2100, etc., the laboratory uniformly uses clean and sealed color steel plate windows, with color steel plates below 1M and tempered glass with a height of 5mm above 1M. The specification is: 1500 × 1000, 1000 × 1000 safety doors are: 1200 * 2100 floor glass doors. The above are standard configurations.
This article is dedicated to the purification and decoration of PCR laboratories. For more information, please click on: http://www.jnyhrs.com Sincere attitude. We will provide you with comprehensive services. We will gradually contribute more relevant knowledge to everyone. Stay tuned
